More Legs

Last night I trimmed the legs to length and cut the huge tenons on one end which will insert into the table base.

The legs are so thick (5” square) that I needed multiple cuts on the table saw to get all the way through. I made them in a series of three cuts, where the following one was made in the kerf of the previous:

The tenons were cut with a dado stack. The stack is 3/4” wide, and the tenon is 3” long, so it took multiple passes:

The arrows in the corner keep track of where the two tapers are going to go, always pointing towards the center of the table:

Next up will be cutting the tapers on the bandsaw!